header

Pre-owned Equipment

Parts Depot

 

Agilent 1200 Series HPLC system

 
Agilent 1200 Series HPLC system
Agilent 1200 Series HPLC system
  This HP / Agilent 1200 Series HPLC system has just been moved from a working lab. It comes with the followings:
Agilent 1200 series 1311A pump

Type

Specification

Hydraulic system

Dual plunger in series pump with proprietary servo-controlled variable stroke drive, floating plungers and active inlet valve

Setable flow

0.001 – 10 ml/min, in 0.001 ml/min increments

Flow precision

£ 0.07% RSD, or £ 0.02 min SD whatever is greater, based on retention time at constant room temperature

Flow accuracy

± 1% or 10 µl/min whatever is greater

Pressure

Operating range 0 – 40 MPa (0 – 400 bar, 0 – 5880 psi) up to 5 ml/min

Operating range 0 – 20 MPa (0 – 200 bar, 0 – 2950 psi) up to 10 ml/min

Pressure pulsation

pulsation < 2 % amplitude (typically < 1 %), at 1 ml/min isopropanol, at all pressures > 1 MPa (10 bar)

Compressibility compensation

User-selectable, based on mobile phase compressibility

Recommended pH

1.0 – 12.5, solvents with pH < 2.3 should not contain acids which attack stainless steel

Gradient formation

Low pressure quaternary mixing/gradient capability using proprietary high-speed proportioning valve Delay volume 800 – 1100 µl, dependent on back pressure

Composition Range

0 – 95 % or 5 – 100 %, user selectable

Composition Precision

< 0.2 % RSD, at 0.2 and 1 ml/min

Control and data evaluation

Agilent control software (e.g. ChemStation, EZChrom, OL, etc.)

Communications

 

Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN optional

Safety and maintenance

 

Extensive diagnostics, error detection and display (through control module and Agilent Lab Monitor & Diagnostic Software), leak detection, safe leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas.

GLP features

 

Early maintenance feedback (EMF) for continuous tracking of instrument usage in terms of seal wear and volume of pumped mobile phase with user-settable limits and feedback messages. Electronic records of maintenance and errors.

Housing

All materials recyclable


Agilent 1200 series G1329A Autosampler

Type

Specification

GLP features

Early maintenance feedback (EMF), electronic records of maintenance and errors

Communications

Controller-area network (CAN). GPIB (IEEE-448), RS232C, APG-remote standard, optional four external contact closures and BCD vial number output

Safety features

Leak detection and safe leak handling, low voltages in maintenance areas, error detection and display

Injection range

0.1 – 100 µl in 0.1 µl increments Up to 1500 µl with multiple draw (hardware modification

required)

Replicate injections

1 – 99 from one vial

Precision

Typically < 0.5 % RSD of peak areas from 5 – 100 µl, Typically < 1 % RSD of peak areas from 1 – 5 µl

Minimum sample volume

1 µl from 5 µl sample in 100 µl microvial, or 1 µl from 10 µl sample in 300 µl microvial

Carryover

Typically < 0.1 %, < 0.05 % with external needle cleaning

Sample viscosity range

0.2 – 50 cp

Replicate injections per vial

1 – 99

Sample capacity

100 × 2-ml vials in 1 tray

40 × 2-ml vials in ½ tray

15 × 6-ml vials in ½ tray (Agilent vials only)

Injection cycle time

Typically 50 s depending on draw speed and injection volume

































Agilent 1200 series G1316A TCC

Type

Specification

Temperature range

10 degrees below ambient to 80 °C

up to 80 °C: flow rates up to 5 ml/min

Temperature stability

± 0.15 °C

Temperature accuracy

± 0.8 °C

± 0.5 °C (with calibration)

Column capacity

Three 30 cm

Warm-up/cool-down time

5 minutes from ambient to 40 °C

10 minutes from 40 – 20 °C

Dead volume

 

3 µl left heat exchanger

6 µl right heat exchanger

Communications

Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN via other 1200 series module

Safety and maintenance

Extensive diagnostics, error detection and display (through control module and Agilent ChemStation), leak detection, safe leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas.

GLP features

Column-identification module for GLP

documentation of column type

Housing

All materials recyclable


Agilent 1200 series 1365B Detector

Type

Specification

Detection type

1024-element photodiode array

Light source

Deuterium and tungsten lamps

Wavelength range

190-950 nm

Short term noise (ASTM) Single and Multi-wavelength

+1 x 10-5  AU at 254 and 750 nm

Drift

2 x 10-3 AU/hr at 254 nm

Linear absorbance range

>2 AU (upper limit)

Wavelength accuracy

+ 1 nm

Wavelength bunching

1 – 400 nm

Slit width

1,2,4,8,16 nm

Diode width

< 1 nm

Flow cells

Standard: 13 µl volume, 10 mm cell

path length and 120 bar (1760 psi)

pressure maximum

Semi-Micro: 5 µl volume, 6 mm cell

path length and 120 bar (1760 psi)

pressure maximum

High pressure: 1.7 µl volume, 6 mm cell

path length and 400 bar (5880 psi)

pressure maximum

500 nano: 0.5 µl volume, 10 mm cell

path length and 50 bar (725 psi)

pressure maximum

Control and data evaluation

Agilent ChemStation for LC

Analog outputs

Recorder/integrator: 100 mV or 1 V,

output range 0.001 – 2 AU, two outputs

Communications

Controller-area network (CAN), GPIB,

RS-232C, APG Remote: ready, start,

stop and shut-down signals, LAN optional

Safety and maintenance

Extensive diagnostics, error detection

and display (through control module

and ChemStation), leak detection, safe

leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas.

GLP features

Early maintenance feedback (EMF) for continuous tracking of instrument usage in terms of lamp burn time with user settable limits and feedback messages. Electronic records of maintenance and errors. Verification of wavelength accuracy with built-in holmium oxide filter

Housing

All materials recyclable

 

 

This Agilent 1200 Series HPLC system is in a great shape. It has been tested at SpectraLab Scientific.    

 

A 90 day warranty is included.  

 

We are professionals. We encourage you to contact us to speak with one of our expert and professional team members. Thanks for looking and we look forward to hearing from you!


 
 
  Price: In Stock Call for Quote
  INQUIRE/OFFER
 
  Please Call Us at Toll Free Number:
1-866-777-3688 Tel: 905-946-8066
 
Contact by email at:
info@spectralabsci.com


 

The one stop shop for all your analytical laboratory needs! Your source for

PRE-OWEND Spectralab Scientific Incorporation CERTIFIED Equipment.

We buy your laboratory or surplus analytical equipment:

Contact buy@spectralabsci.com

Trade-in “service or analytical equipment”:

available via info@spectralabsci.com

*
  Feature Products:
   

Copyright 2014 SpectraLab Scientific Inc. All right reserved. Please contact us by email at: info@spectralabsci.com

Being supported and modified by Spectralab, contact by email at:info@spectralabsci.com